What are the common problems in the maintenance of the container bag sling machine

1. Shape and implement maintenance decision-making plan and time cycle time;
2. After the machinery and equipment have been running for one month, the car oil should be changed once, and every three months thereafter;
3. Ensure that the conductive rollers are cleaned to avoid shutting down when the weft is broken or the frame line is broken due to the difficulty of floating dust. Do well in the security inspection work in the class carefully.
Some parts of the container bag sling machine, such as the spindle support, sliding seat, etc., must be ensured to ensure the distance between the sliding seat and the lower spindle braided line after inspection and disassembly or when replacing with new parts and reassembling. It is recommended to place a sliding frame and its upper spindle to run on the sliding turntable, so that the lower knitting thread will not be hooked or cut off by the sliding frame when it is guided from the pendulum rod to the knitting point.
For rough adjustment, place the spindle on the two adjacent outer spindle supports, use the pendulum rod to guide the braided thread to the braiding point, and then fold it tightly. When the braiding wire of the braiding machine enters or exits from the slot on the sliding turntable track, the distance from the edge of the upper spindle sliding frame must be basically equal. The adjustment of the distance can be realized by changing one or several gears of the gear carrier forward or backward. If you move a tooth that cannot reach the adjustment distance, you can make fine adjustments as follows: loosen the five fixing screws on the inner gear ring. Since the through hole is elliptical, move the inner gear ring to realize the fine adjustment and adjustment of the sliding frame. Tighten the screws when in place. Place the remaining sliding frames evenly on the sliding ring track. If the swing height of the braided wire of the new swing rod is different after installation, it should be adjusted so that all the swing rods have the same stopping point.